RCF CR 16 ND CONTROL RACK, Owner'S Manual

Page: 8 / 24

8
1. Dual Switch Ethercon Connection – Primary port
2. Dual Switch Ethercon Connection – Secondary port for redundant lan connections
3. AES/EBU 8 ch digital outputs
4. AES/EBU 8 ch digital input
5. 16 x XLR male analog inputs
6. 16 x XLR female analog outputs
7. 2 x XLR male Rd-Net outputs
8. 2 x XLR male Aux/Spare inputs
9. LK 25 pin female sockets for audio and Rd-Net parallel outputs
10. Dante A&B connections
11. Rd – Net Control 8 connection
12. DX 1616 connection
13. Guests (other devices connected to the lan)
14. Power over Ethernet
15. Ground lift switch (to open the circuit between grounds)
3.1 CONNECTIONS EXAMPLE
In the following example we are using a system with 12 + 12 HDL 50 A and 16 Subs 9007-AS. In this
case we are using 3 audio signals for A and B sections. 1 audio signal each 4 HDL 50 A modules.
For the subs we are using 4 audio signal from section C. The signal routed to the subs are mono and
it is managed by the DX 1616. We are connected to the switch with a single laptop to set up the Rd-
Net synoptic project and to set up the DX 1616.
We can also control the DX 1616 using Apple IPad or an Android devices, walking in the venue and
making changes in real time.
The processor sold in the CR 16-ND is programmed to help in managing system as the follow
example with the architecture splitted in 4 equal sectors.
Of course CR-16-ND can be used in a standard configuration as a matrix processor with 16 analog
and 8 digital and Dante in/out signal. In the download section of the dedicated webpage
http://www.rcf.it/it_IT/products/touring-and-theatre/dx-1616 , customers will find and download
different project to manage the DX 1616 for different or general purpose use.