J1000/J1100 Wireless Speaker
Installation Guide
NOTE: Once properly installed the TV speakers will no longer
produce sound. All sound from the TV will now come through the
wireless speaker. There is no change to the TV operation. The TV
remote control will still operate the volume of the speaker (make sure
remote is pointed at the TV, not the speaker).
Mounting Instructions (continued)
Install Transmitter
Step 1–
Attach transmitter to top of TV by applying supplied double stick tape to the
“lip” of the transmitter and securing to the top front face of the TV.
Step 2–
Plug AC adapter into the transmitter and wall outlet.
Step 3–
Select “channel” on back of transmitter to match the channel” of the speaker.
Step 4–
Use supplied RCA cable to connect transmitter input to Variable Audio Output
from the TV or use supplied headphone cable to connect from headphone jack of TV.
Step 5–
Adjust Volume Limiter to “MIN” position.
Set-up
Step 1–
After completing step 5 above, use TV remote and adjust volume on TV to MAX.
Step 2–
Incrementally adjust the Volume Limiter on the transmitter from MIN towards
MAX until desired maximum volume is reached for the wireless speaker.
Troubleshooting
• Volume of speaker too low. 1) raise volume on TV, 2) increase volume limiter on the
back of transmitter
• Speaker sounds distorted. 1) The volume limiter on the transmitter is too high, 2)
Lower volume of TV
• No sound comes from speaker. 1) Ensure no cables are plugged into optional port on
back of speaker.
• Sound MUTES occasionally. 1) Raise transmitter and/or speaker height, 2) slightly
angle transmitter up to allow signal to reflect off ceiling.
