55
Playback
Digital Dubbing Using IEEE 1394
Jacks
When sending a digital signal from
one DV device to another, there is
little if any image or sound
deterioration.
To Use This Camcorder as a Player:
1. Make sure the power of both
camcorders is off.
2. Connect one end of the IEEE 1394
cable to each digital camcorder.
3. Press the camcorder’s Play/Pause
Button (
/
) to start playback.
4. While watching the playback on
the monitor, start the receiving
camcorder’s record mode from the
spot on the source tape you want
to begin recording.
Connector Cover
(Open when connecting cables)
IEEE 1394
Connection Cable
DV IN/OUT
Connection Jack
To DV IN/OUT
Connection Jack
Video unit equipped
with IEEE 1394 connector
Notes
:
It is recommended to use the AC adapter/
charger as the power supply instead of the
battery pack for uniform playback.
For digital dubbing, this camcorder can
be connected to only one device at a time.
This camcorder can also be used as the
recording camcorder.
If a blank portion or distorted image is
played back during dubbing, the process
may stop to avoid capturing problem
images.
Even though the IEEE 1394 cable is
connected correctly, sometimes the image
may not appear during playback. If this
occurs, turn off the power and make
connections again.
When using an IEEE 1394 cable, be sure
it has a core filter attached. The core filter
reduces interference and is required to
meet FCC standards.
Dubbing to Another Digital Video Camcorder Equipped With an
IEEE 1394 Connection Port
