RC-Timing RCM Signal, User Manual

Page: 15 / 21

RCM Signal User Manual
(Version 2.0.1.1)
Page 15
6.2.6 Settings/Startsequence
The signals for the direct start will be set here.
The function for 5 different conditions can be set. In the left column the time before
start is set, at which the function is executed. Below the channels K1 to K8 the lights
will be activated., which will be switched on or of.
The column “Aktiv” must be activated, that the function is performed. The Columns
N, P and F mean:
N = normal persistent light
P = short one time flashing
F = continuous flashing
The column “I” is only active if P or F is activated. When I is actiovated, the
functions is performed interleafed. This means, that the previous function is
performed furthermore. The set lights/channels remain on or off, the setting of a
flashing is performed in addition.
6.2.7 Settings/Loop passed
This setting does a signal, when a car passes the loop. This should be set as a one
time flashing together with activated “I” to not change the normal signals.