RC-Timing RCM Signal, User Manual

Page: 10 / 21

RCM Signal User Manual
(Version 2.0.1.1)
Page 10
4.2 Configuration of the Signal-Port
Depending on the Relay Converter you are using, RCM Signal needs also a RS232
Port configuration, where the Signal Converter is connected to. If there is one free
RS232 port on the computer RCM Ultimate is running, you can install RCM Signal
on the same computer where RCM Ultimate is running on. You can connect the
RCM Signal Converter to this port. But you can also use an additional PC connected
to the network to use the ports of this PC.
The settings of the port where the RCM Signal Converter is connected to, can be
changed in Configuration/Options. Left click in the left column on Signal/Relay
Module. In the right column you can choose the module and below the number of
the port.
All other settings should not be changed. They have to be set to
Baud 19200
Data bits 8
Stop bits 1
Paritiy bits None
SW Flow None
HW Flow None
5 File
5.1 Close
RCM Signal will be closed.