UM-1097
Revision B
25
4.2.2
Lock Code
To lock or unlock the system the correct 4 digit authorization number must be entered into the Lock
Code
field. The ViewSmart 1600+ will ask this 4 digit code to be re-entered and then it will be locked. Once
locked, re-entering the code will unlock the unit.
It is very important to record the 4 digit code. However, if lost the controller may be unlocked by entering
the override code: 8621
4.2.3
Modbus®/Web Code
The Modbus® database is normally locked. The register 40099 is used to unlock the unit and allow writes.
When written with the unlock code (found in the security menu). The database unlocks and stays unlocked
while writes occur and for 10 minutes of being idle. The default Modbus® lock code is “1234”.
4.2.4
Web User
Web User allows the user to change the Username for use when logging in to the Embedded Webpage.
4.2.5
Web Paswd
Web Paswd allows the user to change the password for use when logging in to the Embedded Webpage.
4.3
System Configuration Setup
4.3.1
Version
The
Version
line in the System menu displays the version of firmware that is programmed in the
controller.
Configure
Zone Names
Mimic Mode
SD Card
View Event Log
Clear Event Log
View Sensor Life
Inhibit Mode
Version
~
~
~
~
~
~
~
~
v1.00
System
Figure 18 System Menu
Summary of Contents for ViewSmart 1600+
Page 77: ...UM 1097 Revision B 67 4 7 5 4 Programmable Relays Figure 47 Webpage Programmable Relays Menu...
Page 78: ...UM 1097 Revision B 68 4 7 5 5 System Configuration Figure 48 Webpage System Configuration Menu...
Page 134: ...UM 1097 Revision B 124 Appendix 4 Menu Navigation...
Page 141: ...UM 1097 Revision B 131 Wireless Options and Accessories Expansion Options...