RC Systems ST-72, Instruction Manual

Page: 55 / 142

ST-72 User's Manual
Document: UM-1007 Revision Level A
49
2.7.3 ZONE NAMES
ZONES 1-8 names can be edited for a quick reference while in the zone screen. These
16 character names show up in the title bar of each zone.
Zone 2
Zone 3
Zone 4
Zone 5
Zone 6
Zone 7
Zone 8
Zone 1
Tank Farm
West Gate
Switchgear Room
Control Room
Main Process
Zone 7
Zone 8
North Entrance
Zone Names
Configure
Zone Names
Mimic Mode
SD Card
View Event Log
Clear Event Log
View Sensor Life
Version
~
~
~
~
~
~
~
v1.00
System
Figure 2-32
2.7.4 MIMIC MODE
When mimic mode is enabled, the ST-72 will duplicate the data and alarms of another
ST-72 which can be connected with RS485 or TCP/IP. Entering the communications port
and slave ID allows the ST-72 to automatically retrieve programmed configuration
parameters from the Main controller. The Mimic controller’s communication port must
be configured as the Modbus Master and the Main controller’s communication port is
set to Modbus Slave. Once connected the Mimic controller will update automatically
one minute after any parameter is changed in the Main controller. Alarm Reset from
either controller will acknowledge any relay set to
Acknowledge YES ( see section
2.3.1.2 ).
Configure
Zone Names
Mimic Mode
SD Card
View Event Log
Clear Event Log
View Sensor Life
Version
~
~
~
~
~
~
~
v1.00
System
Mimic Mode Enabled
Configure No
COM1
Mimic Mode
Slave ID 1
Figure 2-33