RC Logger 88016RC (RtF), Operating Instructions Manual

Page: 25 / 44

Calibration | 25
16.5 Step 1: Channel learning
■
1x beep confirms a successfully learned channel.
■
2x beeps indicate the completion of the channel learning procedure.
■
Arm LEDs (4), (11): the blink code (e.g. 1 blink) indicates which channel is to be learned
next.
■
Auxiliary switch: Slowly move the switch through all positions and back to its starting
position.
Proceed as follows:
1. Enter the calibration mode.
2. Press the calibration button 2x quickly to enter channel learning (if you use the
transmitter switch ‘SWB’, this step is not necessary).
3. Learn channels according to the following calibration and modes tables.
▬
It is possible to complete the learning procedure after having learned channel 7
by waiting for at least 8 seconds.
4. Tap the calibration button once (1x) to proceed to Gyro Calibration.
LED blinks Control
1x Throttle – Move to min. and back (mid-position)
2x Rudder – Move to left and back
3x Elevator – Move to top and back
4x Aileron – Move to the left and back
5x Flight mode selection switch (3 positions):
▬
Pos 1: GPS
▬
Pos 2: Basic
▬
Pos 3: Expert (no autoleveling)
6x Bank selection switch (3 positions):
▬
Pos 1: Safe bank
▬
Pos 2: Sport bank
▬
Pos 3: Race bank
LED blinks Control
7x Lost locator switch (2 positions):
▬
Pos 1: Lost locator OFF
▬
Pos 2: Lost locator ON
8x Camera tilt
Modes
3
2
1
4 MODE 1
3
4
1
2 MODE 3
1
2
3
4
MODE 2
1
4
3
2 MODE 4
1 Throttle
2 Rudder
3 Elevator
4 Aileron