4
Section 2a –
INSTALLATION
Main Components
Tri-Sensor Assembly
DIG 48 = RC7 Cell
union
Flow In
Flow Out to pool
Control Box
Flow Bypass Manifold Assembly
CONTROL BOX
converts incoming
ELECTROLYTIC CELL
TRI-SENSOR ASSEMBLY
AC power to a Low Voltage DC current,
receives Low Voltage DC current from
ensures that adequate flow,
which energizes the Cell(s). Set the
the Power Circuit Board, which initiates
94.5 L/min. (25 US Gallons/min.)
Control Box
on a vertical surface away
the electrolytic process. This process
minimum;
salt
, 2.8 – 3.2 gm/l
from excessive exposure to heat and
converts ordinary table salt (Sodium
(2800–3200 ppm) ideal range; and
moisture. Use the template to mark and
Chloride) to 100% Pure Sodium
water temperatures
, above
drill the (4) mounting holes and insert
Hypochlorite (Chlorine Bleach) or
15.6
°
C (60
°
F) are satisfactory to
the screws, leaving a ¼ in. gap. Hang the
Bromine (with the addition of Sodium
prevent abusive conditions for the
control box on the screws and level.
Bromide), which in turn sanitizes your
cell to operate. See page 12 for
Remove the cover by following the steps
pool or spa.
instructions to remove and inspect
on page 12 to access the mounting
See page 10 for salt requirements.
the tri-sensor assembly.
holes to tighten the screws.
RATINGS:
Input Power: 115 VAC (3.0 AC amps)
Maximum
Output:Equivalent to 0.82 kg (1.80 lbs) of free available chlorine/day
230 VAC (1.5 AC amps)
RC7 Cell@ Power Level 3 (8 amps DC)
50/60 Hz
Cell Life Expectancy: A minimum of 15,000 ampere/hours
Output Power: Cell Power 1 (5.0* DC amps) Agency Approvals: NSF, ETL us, ETL c, CE
Cell Power 2 (6.5* DC amps)
Cell Power 3 (8.0* DC amps) Internal Pump Relay is rated for 30-amp max.
*Indicates nominal amperage output. The dual axis controller will slightly vary the amps to optimize the power to the cell.
The cell and tri-sensor are located in a Flow Bypass Manifold Assembly. 3.6 m (12 ft.) of
Cell and Tri-Sensor cords
are
provided with the unit. Ensure that the manifold is located within that distance from the control box with enough slack to
allow for removal for service or maintenance.
The Digital display provides full information and diagnostic for maintenance and operation of your system. The programmable
settings are retained on a microprocessor chip with the clock setting backed-up with a CR-2025 lithium battery.
CAUTION:
It is suggested to locate the cell downstream of all other equipment and on the pool return line only to avoid
over-saturation conditions of your spa. For applications other than as recommended, contact the factory.
