RQD031ENr02 Rev. Date: 2021-12-16
9
2.0 SET-UP (FOR DEALER / DISTRIBUTOR ONLY)
2.1 Base Configuration
The base frame can be set up in either of two configurations.
1. Lower configuration allows for seat-to-floor height ranges of 51-58 cm (20-
23”).
2. Upper configuration allows for seat-to-floor height ranges of 61-69 cm (24-
27”). To achieve the upper
configuration, remove the remove all caps and flip the base upside down. Reinstall caps as shown
below.
Lower Configuration (default)
Upper Configuration
2.1 Caster Installation
Tools Required: 5mm hex key
1. Remove the Raz-ART from the shipping carton.
2. Insert one caster stem into caster housing on the base frame.
3. Align the threaded hole in the caster stem with the hole in the
caster housing.
4. Insert the M8 button head screw into the caster housing.
NOTE: Ensure each screw has a thread-lock patch or medium strength
thread-locker solution on its threads before using.
5. Thread the M8 screw through the caster housing and into the
caster stem.
6. Ensure the screw is tightened and caster is secure.
7. Repeat steps 1 to 5 with the remaining 3 casters.
2.2 Back Support Installation
Tools Required: 5/32” hex key, 7/16” wrench
1. Lift the backrest to an upright position.
TIP: A #2 Phillips screwdriver
with a ¼” diameter shaft can be
inserted through one of the plates and back posts to temporarily
hold the back support in an upright position.
2. With the back support in place, insert the ¼-20 button head
screw through the selected hole in the back support mounting
plate and gently push them through the frame tubes. Do not
force the screws through the holes as this could damage the
threads. Use the hex key to turn and thread the screw fully if
needed.
3. Fasten the other end of the screws with curved washers and
lock nuts.
4. Repeat steps 3 to 5 for the other side.
5. Tighten all 4 back mounting screws until all axial clearance is
eliminated but do not overtighten.
