Raytheon HSB L755, Owner'S Handbook Manual

Page: 188 / 224

7-16 HSB Series L755 and L760 Fishfinder
Po
sit
io
n
O
ffs
et
Position Offset
You can offset the vessel position to allow for differences between the GPS
and paper chart data. This may be useful if you are using a datum that is not
available on the Chartplotter, or if you are referring to a paper chart drawn to
unknown datum.
You can change the offset by moving the cursor to the known vessel position.
This offset is applied to all incoming position data. The default offset value is
zero.
When position offset is switched on, all displayed vessel position data is
annotated
(C)
to indicate it has been corrected.
➤
To switch the position offset on/off:
1. Select the
POSITION OFFSET
option, then press the
OFFSET OFF ON
soft key
to toggle the option on/off. The last selected offset value is added to posi-
tion data and the vessel is displayed at the corrected position.
➤
To set a new offset value:
1. Select the
POSITION OFFSET
option, then press the
SET UP OFFSET
soft key.
If necessary, position offset is automatically toggled on.
2. Use the trackpad to move the cursor to the required vessel position; the cur-
sor position is displayed in a position offset data box.
3. Press the
ACCEPT OFFSET
soft key, the vessel is displayed at the new posi-
tion. Press
ENTER
to return to the default display.
➤
To set the offset value to zero:
1. Select the
POSITION OFFSET
option, then press the
SET UP OFFSET
soft key
2. Press the
CANCEL OFFSET
soft key. The position offset value is set to zero.