Raytheon 133-560 NG011, Operator'S And Service Manual, Page: 47 / 63

Repeater
Compass
_________________________________________________________________________________________________________________
Edition: August 2014 4-3 3969.DOC010102
Repeater Compass
133-560
Error code Error type Possible cause Measures
Analogue
indication does not
correspond to the
digital indication
De-synchronisation of
analogue and digital
indication.
Stepping fault of one
stepping motor.
-
Correction of the
analogue
indications
(refer to section 2.9)
Heading indication
correct, cards do
not move
Shaft of the analogue
indication is fixed.
-
Stepping motor
defective or
- electronic defective
Exchange the Repeater
Compass.
Cards and digital
display changing
between two
heading values
Configuration fault
-
Operating fault
-
Check and configure the
interface telegrams and
the operating modes.
Cards do not move
to the lubber line or
keep moving.
Disturbed calibration
-
Restart Repeater
Compass
(Off-On, several times if
needed).
- Exchange Repeater
Compass if necessary.
Heading indication
frozen/constant
External error
-
Disturbed operating
program
-
Restart Repeater
Compass (Off-On,
several times if needed).
One of the cards
turns constantly
Internal error
Magnetic contact is not
detected
-
Restart Repeater
Compass (Off-On)
- Exchange Repeater
Compass if necessary.
Analogue
adjustment is not
successful
Internal error
Zone of possible adjustment
is exceeded
-
Restart Repeater
Compass (Off-On)
- Exchange Repeater
Compass if necessary.
3-line display
switches between
two heading
sensors
Faulty configuration
Check configuration
-
Change configuration
- Restart Repeater
Compass (Off-On)
- Exchange Repeater
Compass if necessary.
2 different heading
data are displayed
alternating
Faulty configuration
External fault
Check configuration
Data transmission faulty
-
Change configuration
- Restart Repeater
Compass (Off-On)
- Exchange Repeater
Compass if necessary.
- Check heading sources