2-9
2.7
Overview Page Settings
Following overview page settings are possible:
•
Change the Current Sensor
•
Change Speed
•
Change Latitude
•
Change Variation (if magnetic compass is selected and the variation is not
distributed by the Distribution Unit, which can receive it from a NMEA RMC
Telegram)
2.7.1
Change the Current Sensor
CAUTION
Not all heading receivers (such as radars) are allowed to use
magnetic heading.
After switching on the operator unit, GYRO 1 is selected as the default compass and the
heading value is displayed.
All other connected and displayed heading sensors can be selected:
1.
Open the overview page.
2.
Use the Select buttons (Figure 2-3/1 and 2) to select a sensor.
3.
Press the Set button (Figure 2-3/11) to confirm the selection.
- The selected sensor will be displayed in the upper half of the display.
2.7.2
Change Speed
CAUTION
It is recommended to read the information about “Individual SEC”
first, before the function “Individual Speed” is applied.
1.
Open the overview page, see chapter 2.3.1
2.
Select Speed with the Select buttons (Figure 2-3/1 and 2).