NautoPilot® 5000 Series
102-890.NG001-NG003
Operator Manual
Edition: 003
77
10000001052
Table 11
Softkeys for Position Monitoring Displays
Function
Figure 39/1
Display, shows the position of a maximum of 2 GPS receivers
and their relative position to the ship.
The position sensor in use (control function of the Autopilot) is
always in the center.
Figure 39/2
Information on heading source and actual heading value.
Figure 39/3
Set heading value.
For Course Control this display is designated as Presel.COG
(Preselected Course Over Ground) after turning the rotary
knob, Set COG after releasing the knob (in increments of
1 degree or 1/10 degree - depends on selected resolution).
For Track Control this display is designated as Track Course.
For Heading Control this display is designated as Set Heading.
Figure 39/4
Touch- icon for switching to a higher resolution for the set
heading value.
Figure 39/5
Numerical display for the rudder angle in degrees; an arrow
next to this display shows the direction of the rudder angle.
Figure 39/6
Softkey for switching to a Setup Dead Reckon display.
Figure 39/7
Softkey for switching to the previous display.
Figure 39/8
Softkeys for changing the selected dead reckoning parameters.
Changes must be acknowledged with a SET (a small icon is
displayed after a change has been made, see also Figure 40).
Figure 39/9
Softkey for copying the calculated set and drift values for the
calculation of a dead reckoning position to the corresponding
adjustable set and drift fields.
These values must be acknowledged with SET (after copying)
to become active.
Figure 39/10 Softkey for switching back to the previous display, without a
transfer of changed values.
Figure 39/11 Numerical indication of calculated Drift; the calculation is based
on the values from the position sensor in use.
Figure 39/12 Numerical indication of calculated set; the calculation is based
on the values from the position sensor in use.
Figure 39/13 Softkey for adjusting an observed drift. This value can be input
from the user and influences the position of Dead Reckoning
on the display.
Value range: 00.0 kn to 99.9 kn
(in increments of 0.1 kn).
