Raytheon Anschütz eLog, Service Manual

Page: 33 / 50

3 Configuration & Maintenance
Edition:002 23 10000000584
► Tab. 5: AIS Settings (Serial Port Parameters)
Area / Element Description
Activate AIS interface
Activates or deactivates usage of data from the se-
rial port.
Check the checkbox to activate usage of data from
the serial port, especially AIS data. If set to false,
the serial port is deactivated and the remaining pa-
rameters in this table can be ignored.
Baudrate
Sets the baud rate of the serial port.
Select the baud rate which is used by the sender
of the serial connection. The default value is
38400
.
Data bits
Sets the number of data bits. The default value is
8
.
Stop bits
Sets the number of stop bits. The default value is
1
.
Parity Sets the number of parity bits. The default is none.
Flow control Sets the type of flow control. The default is none.
CCRP correction longitudi-
nal
Correction in forward direction in meters for the
own ship position delivered by the AIS, in meters.
Heading must be available for the correction. Typ-
ically, no correction is necessary for the AIS own
ship position.
CCRP correction transver-
sal
Correction in starboard direction in meters for the
own ship position delivered by the AIS, in meters.
Heading must be available for the correction. Typ-
ically, no correction is necessary for the AIS own
ship position.
4.
Select the softkey Safe .
► The device reboots.
5. Close the browser window.
► After approximately 3 minutes the electronic logbook can be used again. The
changed settings are now active.
3.1.4 Configure Automated Recording
Requirements
• You must be logged in as an administrator.
About this task
The eLog is able to automatically record navigational data periodically.