Raytheon Anschütz 108-010.NG001 E01, Operator'S And Service Manual

Page: 25 / 80

Magnetic Sonde
7 Installation and Maintenance
Edition:003 15 4423
2. Protect the magnetic compass from turning back.
3. Clean and degrease the glass pane (
Fig. 4 /1) of the magnetic compass with a suitable
agent.
4. Cut out the centering mask ( Fig. 4 /2) and use it to mark the center of the glass pane.
5. Remove the protective papers ( Fig. 4 /3) from the adhesive rings.
Note
Do not touch the adhesive surface with your fingers.
6. Install the magnetic sonde ( Fig. 4 /4) exactly to the marked center of the glass pane.
7. Press for 15 s.
CAUTION!
Hazard due to premature strain of the adhesive bond
Risk of material damage
• Do not strain the adhesive bond during the first 24 hours excessively.
8. Fix the connecting cable for traction relief with a cable tie.
CAUTION!
Hazard due to buckling the connecting cable
Risk of material damage
• Install the connecting cable without buckling.
Close Up
1. Connect the magnetic sonde to the related system or equipment, see chapter 7.3.3 .
7.3.2 Install Junction Box
Requirements
Required Conditions
No conditions
Required Persons
1 Maintainer 1.5 h
Support Equipment
No support equipment
Consumables, Materials and Expendables
No consumables, materials and expendables
Spares
No spares