Accessories
32
Rev. B 09/2011
Pi20
7.4.4
Installation
Locate 2x M4 screws on camera.
Place conduction plate onto camera as shown,
making sure to line up holes on camera with hole
and slot on conduction plate.
Install 2x M4 screws and secure conduction plate
onto camera.
Place the housing internal rail onto conduction
plate as shown on first slot, making sure to place
rail with correct orientation by having rail
securing hole at rear.
Secure rail to conduction plate by installing 2x
screws (truss), 4x curved washers (2x per screw),
and 2x flat washers. Insert the screws until each
screw makes contact with curved washer; curved
washers will be compressed once camera is
installed in enclosure.
Note
: For cameras with remote focus place rail as
shown with one screw in each slot.
