RayTek LineScanner MP150, Protocol Manual

Page: 33 / 42

Appendix
MP150 Protocol
Rev. B4 Aug 2019
33
7 Appendix
7.1 List of User Commands
In this table the interface (sector) refers with n = 1 … 3 to the analog outputs and n = 0 to the digital
interface output.
Description Code Para-
meter Explanation Factory
default Firmware
Revision
Poll parameter G G<code> Example: GES
Ambient
temperature for
ambient radiation
correction A float In case of AC1 this parameter defines the
background temperature in the range of:
min. range ... max range. 27.0 3.20
Ambient
compensation
Control AC d d = 0 ... no compensation
d = 1... with compensation by command
d = 2... with compensation by the voltage
input
0 3.20
Alarm Flag AF nd n=0..3: sector/interface
d=0: reset the alarm flag
d=1: set the alarm flag, it will be held
according to the hold mode
0
Ambient
compensation
bottom (Low)
range
AL integer In case of AC2 this parameter defines the
temperature that corresponds to 0 V at the
voltage input. min. range 3.21
Ambient
compensation top
(High) range AH integer In case of AC2 this parameter defines the
temperature that corresponds to 5 V at the
voltage input. max. range 3.21
Alarm Reset AR - Resets all alarm flags,
like AF n0 for all n -
Accumulation Time AT dddd averaging time in tenth of a second 0 MP50:
limited to
6000 (600 s)
Accumulation
Lines AV integer Has the same effect as AT but is more
precisely by giving the lines instead of
time.
Limited to 9000 lines.
0
Condense N-to-1
Lines AVX n x y Has the same effect as AV, but offers the
option to average, maximum or minimum
n = n lines to condense (like for AV)
x = 0: calculate the average (like AV n)
x = 1: take the maximum
x = 2: take the minimum
x = 3: advanced maximum with y as
threshold
0 0 0 3.30
BootP Client BootPClient d d = 0: switch off
d = 1: switch on
1 (on) 3.43