UK/Europe Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
7.1
Camera Wiring Interfaces
The camera(s) now need to be connected to the VAR2-VLK electrically. There are several things to
consider here and will determine what connections need to be made: -
How will the camera be powered?
o
24V
o
PoE
Does the camera have outputs that need to be used to control part or all of the illuminators?
Does the camera need input from the illuminator or system, e.g. Photocell Status?
How is the video to be distributed?
o
Ethernet
o
Twisted Pair
o
Coax
If two cameras are fitted which will be designated Camera 1 and which Camera 2?
7.1.1
Connections Diagram
Inside the camera housing located in the bottom slot there is a distribution panel which should be used
to make the electrical connections. The picture below shows the connections available.
Camera 1
I/O interface
Camera 2
I/O interface
Camera 2
CAT5e interface
Camera 1
CAT5e interface
Configuration
Mode Dip Switch
CAT5e interface
Camera 1 Supply
Camera 2 Supply
