UK/Europe Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
19
Troubleshoot
Ensure all tests are undertaken by a qualified, trained engineer.
Ensure safe working practices are followed at all times.
Step 1: Basics
Check power supply voltage is correct and applied
Check Telemetry configuration allows lamps on
Check Lamps are not remote disabled
Check Camera supplies are connected and on
Check all interface wiring
If OK…
Step 2: Set-up Camera, lens and illumination
Check alignment of lamp
Match angle of illumination with angle of camera/lens – change angle if required
Check camera lens – fully open at night & set correctly
Step 3: Call Raytec for further assistance
Note down:
Model and serial number of illuminator
Camera make and model(s) in use
Lens make and model(s) in use
If you are still not achieving the stated performance with your VAR2-VLK unit, please contact us for
further assistance.
(Note : The light source (LEDs) of the illuminators is not replaceable. When the unit reaches its end of life
the whole unit shall be disposed of and re-cycled where possible)
