UK/Europe Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
Enable & Disable of Manual Control Buttons (LED A : Flashing AMBER)
RHS LED:
Enable Manual Button Control – Solid GREEN
Disable Manual Button Control – Solid RED
Note : If the illuminator is in Operating Mode and the buttons are currently disabled,
you cannot re-enable.
NOTE – If no buttons are pressed within 2 minutes the illuminator times out and
returns to the previous mode it was in – either Programming Mode or Operating
Mode.
14.5
Disabling the Manual Buttons :
If the Illuminator is in Operating Mode, once the disable manual buttons command is
executed the buttons will be disabled after 30 minutes. This is to allow the user to re-
enable manual buttons if required.
During this 30 minutes the button response will be the following
-
LHS Button
o
Illuminator Settings Mode cannot be accessed. A momentary press of the
button will not be recognised and the indicator LEDs will not change
o
Illuminator Security Mode can be accessed in the normal way by a
continuous 4 second press
-
RHS Button
o
Pushing this button will cause both indicator LEDS to flash RED
Once the 30 minutes has expired any button push (LHS or RHS) will cause
both indicator LEDs to flash RED and the manual buttons are fully
disabled
14.6
Disabling the Manual Buttons Using the Remote :
The manual buttons can be disabled using the remote.
Once the illuminator is put into Operating mode if the disable remote control Set Up
button (see remote section) is pressed again and held for 4 seconds the manual
buttons will be disabled. This is shown by both indicator LEDs flashing RED after 4
seconds.
Note : This command can only be used within 5 minutes of the illuminator being put
into Operating Mode using the Remote Control
(If the Manual Buttons are already disabled , both LEDs will flash RED straight away)
