UK/Europe Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
14.2
Manual Setting / Level Indication using RHS Button :
The RHS BUTTON will only have an effect if you have selected a mode using LHS Button
– pressing RHS Button without previously pressing LHS Button will have no effect on
the Illuminator operation – it is used to control the setting for the mode chosen by LHS
Button
When you select a mode using LHS BUTTON, the LHS LED will confirm which mode you
are in and RHS LED will show the current setting / level of that mode for the
Illuminator.
Sequential presses of RHS BUTTON will take you through the available options to get to
the required setting you want within that mode. The Illuminator will stay at this setting
/ level providing you do not push the RHS BUTTON again. Once you have reached the
required setting as shown in the following text, EITHER press the LHS BUTTON to cycle
through the modes until LHS LED extinguishes showing that you are at the end of the
mode loop OR you can also wait 2 minutes for the illuminator to time out and the
value shown by RHS LED will be stored into the illuminator memory.
The settings programmed will be retained on power recycling unless a reset has been
performed, in which case the factory defaults will be applied.
14.3
Illuminator Settings Mode Detail :
Enter this mode by a momentary press of LHS button to turn LHS LED solid RED.
Pressing the LHS button again will turn the LED solid GREEN and pressing a third time
will turn the LED solid AMBER. Each of these colours indicates which setting mode you
are in.
A further momentary press of LHS Button will exit from the mode entry, both LEDs will
go out for 1 second and then return to the standard indication of either operating
mode or programming mode (depending on which mode the Illuminator was in
previously before selecting manual controls.
The following modes are available :
Power Level Mode (LHS LED : Solid RED)
RHS LED :
20% Power Setting: 1 Flash GREEN
40% Power Setting: 2 Flashes GREEN
60% Power Setting: 3 Flashes GREEN
80% Power Setting: 4 Flashes GREEN
100% Power Setting: 5 Flashes GREEN
