UK/Europe Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
11
Illuminator Modes and Feedback System
11.1
Programming Mode and Operating Mode
On powering up the unit the two illuminators automatically enter Programming Mode. The
Programming Mode automatically times out after 7 Days (or after 30 minutes if the manual buttons are
pressed) or until the user actively changes to Operating Mode. The LED Indicators also give feedback if
you are using the PIN or Manual Control Modes
Factory Default: On initial power-up : Programming Mode.
To enter operating mode from programming mode you can either use Vario Remote Controller or the
manual buttons on the illuminators (please see following sections for detail)
All functions of the remote control and buttons are available in Programming Mode.
The only function of the Remote Control available during Operating Mode is LED Status Indicators
Enable/Disable, entering a PIN or disabling manual buttons (if done at the same time as disabling the
remote).
The manual buttons are available in Operating mode unless they have already been disabled by the user
11.2
Feedback System
During Programming Mode and Operating Mode the two LED’s indicate the following status on the
illuminators (unless detailed below):
LHS SOLID GREEN:
Power Applied
LHS FLASHING GREEN:
Remote control IR received problem
RHS FLASHING AMBER:
Indicates unit is in programming mode
(Programming Mode Only)
RHS SOLID AMBER:
Indicates that a valid command is being received
(Programming Mode Only)
LHS FLASHING RED:
Voltage supply problem detected
LHS SOLID RED:
Illuminator fault detected
