RAYSHAPE Edge E1, User Manual

Page: 11 / 41

9
Installation and Debugging
Installation requirement
In order to obtain the best printing quality, stability and safety, before the installation and use of the RAYSHAPE
3D printer, please be sure to understand the best service environment of the device, and the requirements are
described as follows:
Electrical requirements
• Rated voltage: 100~240VAC,50/60Hz
(Before using, please confirm the power requirements on the nameplate and use the power that meets the
requirements.)
• Rated power: 320W
• The power plug is a two-pole grounded plug, and the device shall be reliably grounded.
Operating ambient temperature, humidity, ventilation, and light
The best operating ambient temperature of Edge E1 is 25-30 ℃ , the humidity is below 60%, the environment
shall be well ventilated (non-confined space), and the device installation location shall avoid direct sunlight.
No dust pollution
Edge E1 contains precision optical components inside the machine body, so the user should ensure that there is
no dust pollution in the service environment, otherwise it will affect the normal operation of the optical devices.
Level and stable platform, away from fire, heat and vibration sources
A level and stable platform is required for Edge E1, away from fire, heat and vibration sources.
Keep the cover closed during printing
During the printing process, please try not to open the cover for a long time, so as to avoid the drastic change of
the resin temperature due to the fluctuation of the temperature inside the printer case, which affects the stability
of the light curing chemical reaction, causing printing failure or poor printing quality.
Use official materials
All official RAYSHAPE materials have been extensively tested and optimized for superior performance, and we
can not guarantee that you can get the same or similar printing performance when using non-designated
materials.
Please note that you are responsible for the loss of printing performance or printer damage caused by the use
of non-designated materials.
Ensure the speed and stability of wireless network
If your device is connected to the router via a wireless network, we recommend that you place the wireless
router and your Rayshape 3D printer as close as possible to ensure high signal strength and data transmission
speed. The router should not be blocked by wall
Note:
Connect your printer to the local network with an Ethernet cable to ensure the best data transmission speed and
network connection stability.