RGB LED Controller
Introduction
1. Power supply input
The controller supply voltage range is from DC 5V to 24V.
Please refer to the print on the controller for cable polarity.
The output voltage is at the same level as the power voltage,
please make sure the power supply voltage is correct and the
power wattage is capable for the load wattage. Please be
noted the positive power cable is directly connected to the
output
cable inside the controller.
Model: T130(-H)
1
3
2
Wireless Remote
Overheat Protection
Wide Voltage Range
Memory Function
Ultra Compact
T130 RGB LED controller is designed to drive constant
voltage LED products with common anode connection in
voltage range of DC5-24V. The receiver works with the remote
controller, user can setup RGB LED color, brightness and
dynamic modes via the remote controller.
Receiver & wiring
1
2
50mm
15mm
38mm
Connect to LED loads. Please refer to the print on the
controller for cable polarity and connect LED load with
2. LED output
according polarity and color sequency. Please make sure the
LED rated voltage is same as the power supply and the
maximum load current is below the controller rated current.
CAUTION! The controller might be permanently
damaged if output cables short circuit. Please ensure the
cables are well insulated to each other.
To 110/230
AC power
5-24V DC output
Power supply
T130 LED
Controller
5-24V DC
LED Loads
LED Controller
5-24V Driving
3. Wiring diagram
Please connect the controller output to LED loads and
power supply to the controller power input. The output
voltage of power supply must be same as the LED load's
rated voltage. Check all cables to be well connected and
insulated before power on.
Remote
Controller
Remote controller function
4
7
4. Turn ON / OFF
Press ‘I’ key to turn on controller or press ‘O’ key to turn
off. The controller will memorize the on/off status and will
restore to the previous status on the next power on. Please
use remote controller to turn on the unit if it was switched to
off status before power cut.
5. Static RGB color setting
The keys in this area set the RGB static color and
brightness. Press the colored keys to set the LEDs to
correspond color as shortcut, press ‘COLOR+’ and ‘COLOR-’
key to select all colors from the preset library, press
and key to adjust color brightness.
* H version picture
5
6
Advanced RF Remote
