4.
SeaTalk
ng
T-piece
5.
Fluxgate compass
6.
Course computer mounting screws and cable ties
7.
Documentation pack
8.
Rudder reference (Not supplied with SPX-10)
9.
Ball joint cap (Not supplied with SPX-10)
10. Ball joint (Not supplied with SPX-10)
11. Rudder reference mounting screws (Not supplied with SPX-10)
12. M6 threaded bar (Not supplied with SPX-10)
2.6 Required additional components
To complete your autopilot system, you will need the following
components in addition to the SPX core pack.
• Compatible autopilot controller.
• Drive unit appropriate for your boat and autopilot course computer.
• Power and drive cables.
Autopilot controllers
There are a number of autopilot controllers available for connection
to your system.
The autopilot controller may be connected using either SeaTalk
ng
or SeaTalk, depending upon the course computer and any existing
marine electronics connected.
S100 REMOTE
STANDBY
PILOT
MODE
D
1
0
4
5
0
-2
1
5
3
2
6
7
4
18
SPX SmartPilot installation instructions
Summary of Contents for SmartPilot SPX-10
