Raymarine RSW-Wired, Installation Instructions Manual

Page: 44 / 74

The RSW wind transducer configuration is initiated from the [Transducer
Set-up] menu: [Menu > Set-up > Transducer Set-up]
1. Select [Continue] to search for connected transducers.
2. Select your RSW wind transducer from the list.
3. If your vessel has a rotating mast:
i. Select [Rotating Mast] and select [On] .
ii. If applicable, select [Adjust Wind Xdcr] and use the [Up] and [Down]
buttons to enter the offset value for your transducer.
• A heading sensor is required for rotating masts.
• The offset should be measured from the mast’s centerline to the
transducer. This may be different from the vessel centerline.
4. If your vessel does not have a rotating mast and does not have a heading
sensor; if applicable, select [Adjust Wind Xdcr] and use the [Up] and
[Down] buttons to enter the offset value for your transducer.
• The offset should be measured from the vessel/mast’s centerline to
the transducer.
5. If your vessel does not have a rotating mast but does have a heading
sensor, no offset value is required, however if poor heading data is
affecting wind data readings you can enable
[Ignore Heading] and if
applicable, use the [Up] and [Down] buttons to enter the offset value for
your transducer from the [Adjust Wind Xdcr] menu.
44