Raymarine RSW-Wired, Installation Instructions Manual

Page: 43 / 74

• The offset should be measured from the mast’s centerline to the
transducer. This may be different from the vessel centerline.
4. If your vessel does not have a rotating mast and does not have a heading
sensor; if applicable, enter the offset value for your transducer.
• The offset should be measured from the vessel/mast’s centerline to
the transducer.
5. If your vessel does not have a rotating mast but does have a heading
sensor, no offset value is required. However, if poor heading data is
affecting wind data readings you can enable the
[Ignore sensor heading
data] toggle switch and if applicable, enter an offset value for your
transducer.
12.3 Configuring RSW wind using i70/i70s
instrument display
The RSW wind transducer can be configured using an i70/i70s instrument
display, running software version 3.21 or later.
Configuration
43