Raymarine RSW-Wired, Installation Instructions Manual

Page: 42 / 74

12.1 RSW series wind transducer configuration
The RSW series of wind transducers requires configuration to ensure
readings are presented relative to vessel heading.
On a non-rotating mast where a heading sensor is present, the wind
transducer will automatically compensate for any offset between installation
angle and vessel centerline (heading).
On a non-rotating mast where no heading sensor is present and the
transducer has not been installed facing directly forwards, it is important
that an offset is applied to account for the difference between the mast’s
centerline and the transducer’s installation angle.
On a non-rotating mast, if poor heading sensor readings are affecting wind
readings, vessel heading can be ignored. However, an offset must be
applied to account for the difference between the vessel’s centerline and
the transducer’s installation angle.
On a rotating mast a heading sensor is required so that wind readings
compensate for mast angle. It is important that an offset is applied to account
for the difference between the mast’s centerline and the transducer’s
installation angle. The transducer will automatically compensate for the
difference between heading and mast angle.
Non-rotating mast example
1. Vessel/mast centerline.
2. Offset angle.
Note:
Offset only needs to be entered if there is no heading sensor.
Rotating mast example
1. Vessel centerline.
2. Mast centerline.
3. Mast rotation.
4. Offset angle.
Note:
A heading sensor and, where applicable, offset angle is required.
12.2 Configuring RSW wind using LightHouse 4
display
The RSW wind transducer can be configured using an Axiom display, running
LightHouse™ 4, version 4.5 or later.
The RSW wind transducer configuration is initiated from the
[Network]
settings menu: [Homescreen > Settings > Network]
1. Select the RSW Wired Gateway from the network list.
2. Select [Configure settings] from the Pop-over options.
3. If your vessel has a rotating mast:
i. Enable the [Rotating mast] toggle switch.
ii. If applicable, enter the offset value for your transducer.
• A vessel heading sensor is required for rotating masts.
42