• Always make sure that PC’s or other sensitive electronic devices have a dedicated power circuit.
Cable shielding
Ensure that cable shielding is not damaged during installation and that all cables are properly
shielded.
Connections to other equipment
Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other equipment using a cable not supplied by
Raymarine, a suppression ferrite MUST always be attached to the cable near the Raymarine unit.
Dust caps
To prevent potential water ingress, connectors not in use should be protected using the supplied
dust caps.
Bare end wire connections
Your product is supplied with bare end wire connections. You must ensure that ALL bare end wires
are adequately protected from short circuit and water ingress.
Bare ended wire connections
It is recommended that bare ended wire connections are made by soldering or using crimp
connectors and then protected by wrapping the connection in insulation tape.
Unused bare ended wires
Any unused bare ended wires should be folded back and wrapped in insulation tape.
4.2 Connections overview
49
