Raymarine Ray 90, Installation & Operation Instructions

Page: 40 / 108

7. When the final digit is confirmed select DONE .
Example
8. The MMSI is displayed onscreen, check that it is
correct, then:
i.
Select Yes – Save , or
ii. if the number entered is not correct select No –
Retry .
Caution: MMSI and ATIS ID
entry
You can only enter the MMSI number and
ATIS ID once!
If you store an incorrect MMSI number or
ATIS ID in your product, it will have to be
reset by an authorized
Raymarine ® dealer.
5.11 Entering your ATIS ID
A unique ATIS ID must be entered before ATIS mode
can be enabled.
From the Main menu.
1. Select
Set-up .
2. Select ATIS set-up .
3. Select ATIS ID .
Not set will be displayed if no ATIS ID has been set.
The first digit is set to a ‘9’ and cannot be changed,
this is because all ATIS IDs start with a ‘9’.
As most ATIS IDs consist of a ‘9’ followed by your 9
digit MMSI number; if your radio already has an MMSI
number the ATIS ID will be pre-filled in this format.
4. If the ATIS ID has been pre-filled, check it carefully
against your issued ATIS ID.
5. To enter your ATIS ID manually, use the Rotary knob
to cycle through the available numbers and press OK
to confirm each number and move to the next digit.
You should only enter the unique 10 digit ATIS ID
provided by your licensing authority.
6. Press the Back button at any time to edit digits you
have already entered.
7. Press and hold the OK button to display options to
Move cursor back and forward through the digits.
8. When the final digit is confirmed select DONE .
Example
9. The ATIS ID is displayed onscreen, check that it is
correct, then:
i.
Select Yes – Save , or
ii. if the number entered is not correct select No –
Retry .
Caution: MMSI and ATIS ID
entry
You can only enter the MMSI number and
ATIS ID once!
If you store an incorrect MMSI number or
ATIS ID in your product, it will have to be
reset by an authorized
Raymarine ® dealer.
Enabling and disabling ATIS mode
ATIS is a European system used on some inland
waterways. A unique ATIS ID must be entered to use
ATIS mode.
With ATIS mode enabled the radio’s region will be
fixed to the INT (international) frequency band and the
following functions are disabled:
• DSC functions
• Watch Mode
• Scan Mode
40