Raymarine Ray 90, Installation And Operation Instruction Manual

Page: 56 / 192

4.6 NMEA 2000 / SeaTalkng ® connection
Your product can transmit data to devices connected on SeaTalkng ® or NMEA 2000 CAN bus
networks. Connection is established using the DeviceNet connector located on the bottom of the unit.
1. Use the supplied DeviceNet to SeaTalkng ® adaptor to connect your product to your SeaTalkng ®
backbone using available SeaTalkng ® spur cables.
2. You can also use a DeviceNet to SeaTalkng ® adaptor cable (not supplied) to connect your
product to an available spur on your SeaTalkng ® backbone.
3. Alternatively you can connect your product to a NMEA 2000 backbone using a standard
DeviceNet cable (not supplied).
Refer to Chapter 14 Spares and accessories for a list of available SeaTalkng ® cables.
Note:
1. The product must be connected to a correctly terminated backbone.
2. You cannot connect your product directly to a MFD.
3. Refer to the instructions supplied with your SeaTalkng ® / NMEA 2000 device for details on
creating a backbone.
56