Raymarine MICRO-TALK, Installation Instructions Manual

Page: 57 / 84

ii. Confirm by pressing any button on the same display.
The display will show ‘
DONE
’.
If confirmation is not completed within 25 seconds, ‘FAIL’ will be shown which means the display
has not joined the network.
When the countdown is complete, the chosen display returns to the Autonetworking page. Press
and hold the
Set up button for 2 seconds to return to normal operation.
11. Test the system:
i. Switch off the chosen display.
ii. Switch on the chosen display.
If some units do not power up, check that all new units are within 300 mm (11.8 in) of the
chosen display and if required, are connected to a power source.
12. Repeat the steps above until all units have joined the network.
13. If you are replacing older units, remove them from the vessel.
14. Ensure all units are working correctly before mounting them.
Product identification on Micronet
The Micro-Talk gateway is identified differently during the Autonetworking process than when
checking the Health pages from a Micronet display.
During Autonetworking the gateway is identified as an NMEA 2000 device (i.e.:
2000
,
N2000
,
or
N 2000
)
When checking the Health pages from a Micronet display the gateway is identified as Type 7 device
(i.e:
TYP7
,
TYPE7
or
TYPE 7
.
9.3 Powering the unit on and off
Powering on
The Micro-Talk unit will automatically power on when power is applied to the SeaTalkng ® network
that the unit is connected to.
Powering off
The Micro-Talk unit is powered off when the SeaTalkng ® network it is connected to is powered off.
9.4 Data damping
Data damping affects the responsiveness of display data to changes in the data received from
connected transducers/sensors. A less responsive setting removes data fluctuations and provides
a more stable reading. A more responsive setting results in a more dynamic update to changes
to the data.
Response settings are available on both MicroNet and SeaTalkng ® networks to control data damping.
As the Response settings on each network are independent of each other, there is a risk that data
can be double damped, once on MicroNet and then again on SeaTalkng ®. To minimize the effect
of double damping, you should reduce the relevant
Response setting on MicroNet displays and/or
increase the Display Response setting on SeaTalkng ® displays.
Note: It is recommended that MicroNet Response settings are set to either Slow, Medium or
Fast rather than Auto.
System operation and setup
57