Raymarine LIGHTHOUSE 3, Advanced Operation Instructions

Page: 42 / 450

Powering off the display
1. Press the Power button.
2. From the Shortcuts page press and hold the power icon for approximately 2 seconds.
Alternatively you can press and hold the Power button for approximately 6 seconds to power off
your display.
Note:
When powered off, the unit may still draw a small amount of power from the battery. If this is a
concern, unplug the power supply or switch off at the breaker.
4.4 Switching on and off at the breaker
If you wish to ensure that the MFD is not consuming any power then it must be switched off at the
breaker or have the power cable unplugged.
When the breaker is switched back on, or the cable is reconnected, the MFD will resume in the same
power state that it was in when it was switched off.
4.5 Getting started
First power up
When you power up your new Multifunction Display (MFD) for the first time a number of actions
are required.
The list below shows the actions that should be performed on your new MFD:
1. Power on the display.
2. Select your Data master (only required on networks with more than 1 MFD).
3. Complete the Startup wizard (the wizard will not be shown if you are connecting to an existing
system that has already been set up).
4. Read and agree to the Limitations on Use disclaimer.
5. Select/check your preferred Data sources , if required.
6. Perform Engine identification , if required.
7. Select/check Transducer settings , if required
42