Raymarine LIGHTHOUSE 3, Advanced Operation Instructions

Page: 108 / 450

Menu item and description Options
Motor phasing (1)
Switches the polarity of your drive motor.
Use if your drive polarity is inverted.
• A
• B
Rudder offset
(3)
Adjust to specify the rudder offset from amidships.
• -10° to +10°
• 30° (default)
Rudder limit
Specifies how far the rudder can move before hitting its end stops.
The value should be set to approximately 5° less than your maximum
rudder angle.
• 10° to 50°
• 30° (default)
Hard over time
Specifies the time it takes for the rudder to move from hard port to hard
starboard or vice versa.
The default value is determined by your
Drive type selection.
• 1 to 100.0 seconds
Gybe inhibit (2)
When set to Prevent Gybe the autopilot will prevent you from performing
an Auto tack away from the wind.
• Allow Gybe
• Prevent Gybe
Wind data type
(2)
Selects whether wind data is True or Apparent.
• Apparent
• True
Wind shift alarm
(2)
Enables and disables the Wind shift alarm.
• On
• Off
Note:
• (1) Option not available when Calibration lock is On .
• (2) Only available when Vessel hull type is set to a Sailing vessel.
• (3) Only available when a rudder reference transducer is connected.
108