Raymarine i50 Depth, Installation And Operation Instructions Manual

Page: 45 / 90

7.3 Power
Powering on the unit
With power to the unit turned on but the unit switched
off:
1. Press and hold the
Power button until the unit
powers on and data is displayed (approximately
2 seconds).
Note: When power to the unit is turned on the unit
will switch on automatically.
Powering off the unit
1. Press and hold the Power button until the power
count down timer is displayed and reaches zero
(approximately 6 to 8 seconds).
7.4 Data master
Where a system contains more than one unit
capable of displaying a data type, the unit physically
connected to the transducer must be set as the data
master and any other units set as a repeater.
Checking i50 Speed software version and
status
1 0
15
20
25
30
35
40
45
50
55
60 5
4 +
D12452-2
S pe e d T rip
S pe e d
During normal operation:
1. Press and hold the
Speed and Trip buttons at
the same time for approximately 4 seconds, until
the Software Version page is displayed.
2. Press the Speed button to display the instrument
status.
Master (transducer connected) or Repeater (No
transducer connected).
3. Press the Speed button again to begin the Speed
Run Calibration.
4. To exit the Intermediate Calibration settings at
any time, press and hold the Speed and Trip
buttons at the same time for approximately 4
seconds.
i50 Speed
45