Hydraulic Linear Drive - Installation Guide
5
Installation instructions
Parts required
To install this drive you will need:
•
Parts supplied:
•
pre-filled and pre-bled system consisting of: hydraulic ram;
hydraulic pump; hydraulic pipes; fluid reservoir (supplied
fitted with transit cap; standard cap also supplied)
•
hydraulic fluid (to fill reservoir)
•
tiller pin assembly (see Figure 7) consisting of: tiller pin,
R-clip, top washer, lock washer, nut (UNC nylock)
•
Additional parts:
•
suitable securing bolts and lock washers/lock nuts for the
hydraulic ram and pump (see page 9)
•
suitable cable and electrical connectors for the drive motor
and clutch (see page 12)
Note: Make sure you have obtained these additional parts before you
start installation.
Installation steps
WARNING: Electrical safety
Make sure you have switched off the power supply before you
start installing this product.
Follow these steps to install your hydraulic linear drive system:
Ï
Ï
Ï
1
Consult the EMC installation guidelines.
page 6
2
Mount the drive system components.
page 7
3
Connect to the course computer.
page 12
4
Complete the post-installation check.
page 14
