Raymarine hsb2 PLUS Series, Owner'S Handbook Manual

Page: 208 / 248

8-30 hsb
2
PLUS Series Color LCD Display
Data Ou
tpu
t
Data Output
Data is transmitted in SeaTalk and NMEA formats as detailed in Appendix D
and can be used to enhance other equipment as required. You can disable the
transmission of individual NMEA output sentences - refer to
NMEA Out Set
Up on page 7-9 .
The SeaTalk input/output connection is detailed in SeaTalk Connection on
page 8-27 .
The NMEA output connector is a 4-pin connector as illustrated below. The
1.5 m NMEA OUT cable has a ferrite clamp attached to ensure EMC
conformance.
Figure 8-19: NMEA Output Connector
Data Conversion
The hsb
2
series displays convert some information across the communications
links as follows:
NMEA In to NMEA Out and SeaTalk
SeaTalk to NMEA Out
This enables data received by the display to be passed to other instruments. For
example, if you have a master and a repeater display, you only need to connect
NMEA In to the master display, which will pass the data to the repeater via
SeaTalk.
You can prevent NMEA heading data being bridged onto the Seatalk bus -
refer to
Bridge NMEA Heading on page 7-8 .
Note: To transfer NMEA data, or to convert the data, the display must be pow-
ered On.
Pin 2, white
Pin 5, screen
Pin 3, blue
Pin 4, not connected
*Pin 1 does not exist on this connector
NMEA OUT connector
NMEA OUT connector
Pin Pin name Function
2 NMEA_GND NMEA ground
3 NMEA_SIG NMEA data output
4 N/C N/C
5 CGND Screen
2
4 5
3
Rear of display
NMEA out
D4254_1