Raymarine gS Series, Installation And Operation Instructions Manual, Page: 205 / 208

29.10 Bluetooth troubleshooting
Aspects of the installation can cause problems with the data shared between wireless devices. Such problems, their possible
causes and solutions are described here.
Problem Possible causes Possible solutions
Ensure that Bluetooth is enabled on the multifunction display (
Homescreen: > Set-Up > System Settings > Connections >
Bluetooth > On
).
Ensure that the “Bluetooth” option is enabled on the iPhone (available
from the phone's Settings / General menu).
No wireless connection. iPhone does not have a Bluetooth
connection established with the
multifunction display.
Ensure that the Bluetooth device is paired with the multifunction display
that you want to use it with. To do this:
Homescreen: > Set-Up >
System Settings > Connections > New Bluetooth Connection .
Media player device is not compatible
with the Bluetooth 2.1+ EDR power
class 1.5 (supported profile: AVRCP
1.0) or higher.
Check the Bluetooth compatibility with the device manufacturer. If the
device is not Bluetooth 2.1+ EDR power class 1.5 (supported profile:
AVRCP 1.0) compatible then it is not suitable for wireless use with the
multifunction display.
No media player control.
“Audio Control” is NOT enabled on the
multifunction display. Enable “Audio Control” ( Homescreen: > Set-Up > System Settings >
Connections > Connections Manager > Audio Control > On ).
Weak or intermittent Bluetooth signal. Interference from other wireless devices
in the vicinity. Multiple wireless devices running simultaneously (such as laptops,
phones, and other wireless devices) can sometimes cause wireless
signal conflicts. Temporarily disable each wireless device in turn until
you have identified the device causing the interference.
Troubleshooting
339