4.4 Legacy transducer connection
When connecting a legacy transducer you must use the correct adaptor cable and, where required
an extension cable that is compatible with the legacy transducer.
1.
Element™ HV display — Connects to adaptor cable..
2. Adaptor cable (i.e.: A80559 or A80558) — Connects to the display and extension cable or
transducer.
3.
Extension cable (i.e.: A80312, E66074 or A80273) — Connects between transducer and adaptor
cable.
4.
Example legacy transducer — Connects to adaptor cable or extension cable.
Legacy transducer extension cables
When connecting a compatible legacy transducer to an Element display, using an adaptor cable:
if the cable run requires extending, you must use an extension cable which is compatible with
your transducer.
Important:
The HyperVision™ extension cable cannot be used to extend the cable run of legacy transducers.
Legacy transducer
Compatible extension cable
Dragonfly® transducers
A80312 — 4 m (13.1 ft) Dragonfly® transducer
extension cable.
Note:
Power supply wires should be isolated and
protected from shorting or water ingress.
DownVision™ transducers
E66074 — 3 m (9.84 ft) DownVision™ transducer
extension cable.
High CHIRP sonar transducers
A80273 — 4 m (13.1 ft) CPT-S transducer
extension cable.
41
