LightHouse 3 connection screen:
Important:
• Ensure that the SSID and Passcode are entered exactly as shown on the serial number label
that was supplied with the Radar.
• The SSID is always made up of the word “
Quantum
”, followed by an underscore “
_
”, followed by
the product’s 7 digit
serial number
, (e.g.
Quantum_1234567
).
7. Select
Connect
.
The initial connection can take up to 2 minutes to complete. If the connection does not complete
within 2 minutes, power cycle the Radar and repeat Steps 4 to 7.
8. Select
OK
from the Successful Connection pop-up.
9. Open a Radar application page.
10. Check that the reported Radar on the power / transmit pop-up is the Radar that you have just
paired with.
11. If the correct Radar is reported, select
Tx
(Transmit).
12. If the reported Radar is not the Radar scanner you just paired with, select the correct Radar from
the Radar application menu:
Menu > Select Radar:
and then select
Tx
(Transmit).
The Radar image can be displayed on all networked MFDs.
MFD access point connection when connected to Quantum Wi-Fi
Depending on you MFD variant, you may be restricted from connecting your MFD to a Wi-Fi access
point, if a Quantum Radar that is connected using Wi-Fi is currently transmitting on the system.
a
,
c
,
e
,
gS Series
and
Axiom
MFDs CANNOT connect to a Wi-Fi access point if there is a transmitting
Wi-Fi connected Quantum Radar in the system. To connect these MFDs to a Wi-Fi access point the
Quantum Radar must be placed in Standby mode first.
eS Series
and
Axiom Pro
MFDs CAN connect to a Wi-Fi access point at the same time as being
connected to a transmitting Wi-Fi connected Quantum Radar.
Standby and sleep modes for Wi-Fi connections
The radar scanner has 2 modes which may initially prevent you from successfully pairing the radar to
an MFD via Wi-Fi, in the event that the Wi-Fi connection between the 2 devices is lost. These modes
are part of the scanner’s normal operation, but it’s important to understand how these modes can
potentially impact the pairing process.
•
Sleep mode
— If the connection to the MFD is lost while the scanner is in
Standby
mode, the
scanner will switch to Sleep mode within 30 minutes. When the connection to the MFD is restored,
System checks and troubleshooting
67
