Raymarine AXIOM 2 PRO, Installation Instructions Manual

Page: 52 / 126

Note: You can NOT connect RealVision™ Max 3D, RealVision™ 3D,
DownVision™ or SideVision™ transducers to an S variant display.
6. NMEA 2000 — The NMEA 2000 connector enables connection to a
SeaTalkng ® or NMEA 2000 network using the supplied SeaTalkng ® to
DeviceNet adaptor cable or a suitable DeviceNet cable.
7. Network — The 2 x network connectors enable connection of RayNet
devices.
8. Ground — The optional grounding point should only be used when the
display experiences touchscreen interference from nearby equipment.
The grounding point should be connected to the same RF ground point
as the interfering equipment, or the vessel’s negative battery terminal.
9.4 Connecting cables
Follow the steps below to connect the cable(s) to your product.
1. Ensure that the vessel's power supply is switched off.
2. Ensure that the device being connected has been installed in accordance
with the installation instructions supplied with that device.
3. Ensuring correct orientation, push cable connectors fully onto the
corresponding connectors.
4. Engage any locking mechanism to ensure a secure connection (e.g.: turn
locking collars clockwise until tight, or in the locked position).
5. Ensure any bare ended wire connections are suitably insulated to prevent
shorting and corrosion due to water ingress.
9.5 Bare end wire connections
You must ensure that any bare end wires are adequately protected from
short circuit and water ingress.
Bare ended wire connections
It is recommended that bare ended wire connections are made by soldering
or using crimp connectors and then protected by wrapping the connection in
insulation tape.
Unused bare ended wires
Any unused bare ended wires should be folded back and wrapped in
insulation tape.
52