Raymarine AXIOM 2 PRO, Installation Instructions Manual

Page: 48 / 126

Surface mounting
Follow the steps below to surface mount the display.
Important:
In above decks installations, marine-grade sealant should be used to seal
the gap between the edge of the mounting surface and the edge of the
display.
1. Ensure you have followed the instructions for preparing the mounting
surface for surface mounting.
2. Route the relevant cables to behind the mounting surface cut out.
This may be difficult or not possible once the display has been mounted.
3. Remove the backing from the supplied gasket and place the sticky side
of the gasket onto the flange on the rear of the display and press firmly
onto the flange.
4. Connect the relevant cables to the rear of the display.
5. Slide the display into the cut out area.
6. Pull back the 3 corner bungs and open the card reader door.
7. Insert the fixing bolts, attach the washers and nuts from the rear and
tighten.
8. Close the 3 corner bungs and the card reader door.
Note:
The supplied gasket provides a seal between the display and a suitably
flat and rigid mounting surface or binnacle. The gasket should be used in
all installations. It may also be necessary to use a marine-grade sealant if
the mounting surface or binnacle is not entirely flat and/or has a rough
surface finish.
48