Raymarine AXIOM 2 PRO, Installation Instructions Manual

Page: 45 / 126

• A — Cut out (when flush mounting the cut out will be the same size as
for surface mounting.
• B — Flush mounting requires an extra rebate to recess the display fully in
the mounting surface.
Important:
When flush mounting the fixings go through holes drilled in the rebated,
and therefore thinnest, part of the mounting surface. Before preparing the
mounting surface ensure that sufficient thickness will remain to secure
the display.
1. Mark the Cut out line identified on the supplied mounting template on
the mounting surface.
2. Mark the 4 hole for fixing screws locations identified on the supplied
mounting template on the mounting surface.
3. Mark the Rebate for flush mount line identified on the supplied mounting
template on the mounting surface.
4. Use a drill and an appropriate size drill bit or hole cutter to cut out the
corners of the Cut out line.
The corner diameter for the displays are:
• 33.00 mm (1.30 in) — Axiom® 2 Pro 9.
• 37.00 mm (1.47 in) — Axiom® 2 Pro 12.
• 38.00 mm (1.5 in) — Axiom® 2 Pro 16.
5. Use a jigsaw or similar cutting tool to cut out the remainder of the cut
out area.
6. Drill the 4 fixings holes at the marked location using a 3.7 mm ( 5 /
32
”)
drill bit.
7. Use a router hand tool to recess the marked rebate area to a depth of
15.00 mm (0.59 in).
8. Use a half round file and/or sandpaper to smooth and rough edges or
burs on the cut out hole.
Flush mounting
Follow the steps below to flush mount the display.
Important:
In above decks installations, marine-grade sealant should be used to seal
the gap between the edge of the mounting surface and the edge of the
display.
Installation 45