Raymarine AXIOM 2 PRO, Installation Instructions Manual

Page: 118 / 126

Note:
• It is the OEM’s responsibility to ensure that an appropriate UV resistant
ink is used for pad printing on the name plaque.
• The ‘Raymarine’ branding on the standard name plaque is painted
using gloss black Marabu Tampa Star TPR 980 ink, and pad printed
onto the name plaque. Using this ink type and print method should
be sufficient.
However, it’s important that you perform your own
testing to ensure suitability . Refer to the Marabu website for ink details:
https://www.marabu-inks.com/
• This information is provided for information only. Raymarine will not be
held liable for the use of inappropriate ink or printing methods.
Appendix B Replacing the card reader door
The card reader door and card slot cover are a single piece. If the card
reader door or card slot cover becomes damaged it can be replaced using
the Card reader door spare (part number: R70891.
To change the Card reader door follow the steps below.
1. Open the Card reader door.
2. Unscrew the hex screws using a 1.3 mm a/f hex wrench (Allen key).
3. Remove the plastic bar.
4. Remove the Card reader door.
5. On the new Card reader door, insert the card slot cover ensuring it is
correctly seated.
6. Hold the card reader door in the open position and reattach the plastic
bar and secure using the hex screws, tightening the screws evenly.
7. Ensure you do not over tighten the screws.
8. Close the Card reader door ensuring that it sits flush with the bezel
around the bottom of the door.
118