4 INSTALLATION
© 2022 RAYLASE GmbH SUPERSCAN IV
MN105-en / v1.0.12
32
4
INSTALLATION
Installation may only be carried out by trained personnel. These trained personnel must be familiar
with the general safety regulations that are applicable for installation and operation of opto-
mechatronic systems, machines, and plant.
4.1
Safety during installation
WARNING
Hazard due to electrical energy
C 3-0 10. 1
The deflection unit is designed for operation with a safe extra-low voltage supply (< 60 V DC). The
operator is responsible for safety of the power supply (voltage limitation, shutdown on overcurrent,
line protection).
Make sure that the power supply does not exceed the specified low voltage.
During all work on the electrical power supply and the electrical systems, observe the relevant
electrical safety regulations.
WARNING
Risk of injury due to laser radiation
C2 -01 0
The laser beam (including a reflected beam) can cause severe injuries to the eyes and skin.
The laser system may only be installed and started up by trained personnel.
Before carrying out any work, make sure that the laser equipment is switched off and secured
against being switched on again.
After all work, make sure that all housing covers are in place.
WARNING
Risk of injury due to falling product
C2 -03 0
A falling product unit can cause injuries.
The product should be installed by two people wearing suitable safety shoes.
In case the product fell down it must not be used any more. It has to be sent back to RAYLASE
for service.
