Wuhan Raycus Fiber Laser Technology Co., Ltd
User manual QCW450/1500
12
use electric fan to dissipate heat when it is hot every day in summer, so as to
avoid large dust in the air).
9) The minimum bending radius of the fiber should not be less than 20cm
under non-working conditions such as transportation and storage. The minimum
bending radius should not be less than 30cm when the laser is working
CAUTION:
All the cables can only be connected when power supply
is off. It is possible to damage the laser by installing the control line
under electricity
The laser fiber connector must be placed in a natural state as far as
possible. It is forbidden to twist the fiber connector
。
If the twine diameter of the feeding fiber is too small, the laser will be
damaged
。
In the process of installation and disassembly, please handle the fiber
connector with care to avoid vibration
。
Before assembling the laser fiber connector, the optical lens and the
cavity of the cutting cable must be clean and pollution-free
。
Please keep the protective cap of the fiber connector properly to
prevent it from being polluted; otherwise, the fiber connector will be
indirectly polluted when the protective cap is put on.
4 Using the product
4.1
Front Panel
Figure 6 shows the front panel of the laser.
Figure 6 Front Panel
