User’s guide Ytterbium Pulsed Fiber Laser RFL-P20MB Ver.: 2.0
Please make sure the control system is on before you turn on the fiber laser. Only after at
least 1 minute since the power turned on, the subsequent operations can be proceeded.
2)
Frequency set introductions
The frequency setting range is from 10 kHz to 1000 kHz.
3)
Laser marking checking
For the device initial testing, first turn the power down to zero without turning on the
marking system after the device is successfully started. Then draw a quadrate, marking
continuously while slowly increasing the power from 0% to 100% at the same time. Meanwhile,
use a ceramic material to observe the laser and the laser should become stronger, otherwise shut
down the device and check. If operating normally, the marking system can be used in common
order afterwards.
4.3 Cautions
1)
Marking frequency must be in the range of 10 kHz to 1000 kHz.
2)
It should not modify the frequency while marking.
3)
Stop marking first before shutting down the device, then turn the power down to zero and cut
the power off.
5. Instructions for warranty, return and maintenance
5.1 General warranty
All products are warranted by Raycus against defects and problems in materials and
workmanship during the warranty period according to the purchase order or specifications and
we guarantee the product will accord with the specification under normal use.
Raycus has the right to choose to repair or replace any product that proves to be defective in
materials and workmanship selectively during the warranty period. Only products with particular
defects are under warranty. Raycus reserves the right to issue a credit note for any defective
products produced in normal conditions.
5.2 Limitations of warranty
The warranty does not cover the maintenance or reimbursement of our product of which the
problem results from tampering, disassembling, misuse, accident, modification, unsuitable
physical or operating environment, improper maintenance, damages due to excessive use or not
10
/
11
