50
alarm only occurs when the laser emission.
Solution:
Please restart the laser, check the guide laser state of the laser, and through the
clientware "from the control module" reading the scattered light monitoring
voltage value, and contact Raycus.
Laser Power Alarm
Instruction:
The alarm is generated when the emission of the laser cannot reach the set
value. Power error occurs only when the laser is emitting.
Solution:
Please restart the laser, check the red light state of the laser, and contact
Raycus.
ACDC Alarm
Instruction:
ACDC Error, failure of the laser power supply or sudden power failure of the
power supply system may cause an alarm.
Solution:
Check if the input AC voltage is normal. Restart the laser, if this error
continues to occur, please contact Raycus.
Current Driver
Alarm
Instruction:
Current Driver Alarm, this error occurs when the constant current driver board
inside the laser is abnormal.
Solution:
Restart the laser, If this error continues to occur, please contact Raycus
In addition to the above, if there are any questions or errors in using of the laser, you can
contact Raycus to get help.
6 Warranty, Return and Maintenance
6.1 General Warranty
Raycus warrants that all Raycus fiber laser products are conformed to applicable product
specifications under normal use and are free from defects in materials and workmanship. The
warranties start on the date of shipment from Raycus for a period of time as set forth in the
applicable purchase contracts or product specifications. Raycus has the right to choose to repair
or replace any product that proves to be defective in materials and workmanship selectively
during the warranty period. Only products with particular defects are under warranty. Raycus
reserves the right to issue a credit note for any defective products produced in normal conditions.
