39
Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL-C8000S-CE
Programming Mode
The laser is determined by the edit waveform
Open: The current program
number is not 0.
ON mode
Laser ON -- Start the program to execute
Laser OFF -- Terminate the program
External
modulated modes
in REM mode
INTERFACE24 pin 15, 16 pin voltage:
Rising time -- Start the program to execute
Falling time -- Terminates program running
Close: The current program
number is 0
Do not execute a programming program
When the current program number of the laser is not 0 , the laser runs in Program Mode.
Please use the software of Raycus to edit the waveform, and select the program number of
pre- run. The output waveform of laser is determined by the edited waveform. Under the
condition that all working conditions are met, the relation diagram of laser and programming
waveform in programming mode is as follows:
Figure 26 Relationship between laser and programming waveform in programming mode
4. 10.2 The Programming Setup Interface (Waveform editing)
Select "Show programming mode" in "Mode Selection" on the clientware of the laser, as
shown in Figure 27, and the "Program Setting" option appears on the display interface of the
clientware, as shown in Figure 28. Click "Program Setting" to enter the program setting interface,
as shown in Figure 29.
